Used for silicone glue to metal, plastic,rubber...
To be kept out of the heat and sun.
Drying at room tempreture for 5 minutes
20g/bottle or 500g/bottle
Packaging & Delivery
silicone adhesive,RTV silicone packing
or as your requirements.
HTV Silicone adhesive KL-301AB
Double Component Silicone Adhesive
KL-301A/B two component adhesive swiftly cured to be silicone rubber at high temperaturecondition. Elastic and tight bond between cured type of silicone rubbers . The adhesive is characterized with good flowing ability before curing and elasticity electrical insulation property after cured.
The Silicone rubber is damaged
when break off the bonding units
Glue amount drops to 75% , Bonding effect 30% higher
No Whity ,No getting hardened
after the KN-301AB cured
Withstand water boiling tests
Mix viscosity(25℃),mΡa.s: 50000
Specific Gravity(g/cm³): 1.10
Operable time(25℃),h: 4.0
Curing time(80℃),min.: 30-60
Tensile strength(Mpa): 4.0
Hardness(Shores A): 35±5
Adhesive property: ≥2.0(A1-A1,cohesive failure)
Volume resistance(Ω • cm): 1×10
Dielectric strength(KV/mm): 20
l Application ratio: A:B=1:1(weight ratio)
l The adhesive is added by weight ratio and requires thorough mixture.
l Preheat the silicone rubber bonding areas a while before applying on the mixed adhesives KL-301AB.
l Heating at temperature 170°C for 10-15 Seconds.
1,Need to clean surface for bonding,avoid the greasy dirt. 2,Make sure uniform pressure to keep bonded parts together 3,KN-301AB is easy to cure once contacting with moisture, it must be stored in a completely sealed packaging and away from the away from light and hot. 4,Avoid eye contact adhesive,If contact ,rinse with water immediately ,then go to see the doctor. 5,Please fasten down the the caps after using to avoid the gel to be cured.
1KG/Bottle , 3KGS/Bottle
6 Months (20℃-25℃ avoid light ,heat and place in dry area)